Sponsored

X

Jaxmax

Well-Known Member
First Name
Jack
Joined
Jun 28, 2020
Threads
54
Messages
2,856
Reaction score
4,637
Location
Bally, Pa.
Vehicle(s)
Jeeps....... 2021 Mojave , 2019 Wrangler
Occupation
Electrical Manager
Rear locker sensor failure, search threads but I had it on my Mojave at about 90 miles, will become more often then eventually the jeep will disable rear locker and give a service light, before the fix from Jeep was to replace the whole rear axle assembly. The sensors are avalible now or....do what I did get a tazer sensor bypass, install it and move on, mine works fine, I might fix it someday, but all my dash lights work locker locks, but the sensor which is disconnected does not confirm it, but you can tell by seat of pants. There are some long threads about it, basically fine metal particles get into magnet of sensor. some had multiple failures.....Jack
 

NachoRuby

Well-Known Member
First Name
Chad
Joined
Apr 28, 2021
Threads
28
Messages
2,992
Reaction score
4,428
Location
Pennsylvania
Vehicle(s)
'21 JTR , '18 JLU, 73 VW Bug, 97 VW Jetta, all MTs
Rear locker sensor failure, search threads but I had it on my Mojave at about 90 miles, will become more often then eventually the jeep will disable rear locker and give a service light, before the fix from Jeep was to replace the whole rear axle assembly. The sensors are avalible now or....do what I did get a tazer sensor bypass, install it and move on, mine works fine, I might fix it someday, but all my dash lights work locker locks, but the sensor which is disconnected does not confirm it, but you can tell by seat of pants. There are some long threads about it, basically fine metal particles get into magnet of sensor. some had multiple failures.....Jack
They have just the sensor available now, without replacing the whole thing.
 

Sponsored

ToJTornottoJT

Well-Known Member
First Name
Ryan
Joined
Jun 27, 2021
Threads
51
Messages
424
Reaction score
488
Location
Tempe
Vehicle(s)
'21 Jeep Gladiator Rubicon EcoDiesel, 1997 Jeep XJ
Occupation
Real Estate Appraiser/Broker
Mine did this one Monday. I took it to the dealer and it magically was fixed. They said they didn't do anything; however, the plug and harness on the rear end had obviously been unplugged and cleaned and the plugged back in since they were perfectly clean and everything else wad dusty.
 

ToJTornottoJT

Well-Known Member
First Name
Ryan
Joined
Jun 27, 2021
Threads
51
Messages
424
Reaction score
488
Location
Tempe
Vehicle(s)
'21 Jeep Gladiator Rubicon EcoDiesel, 1997 Jeep XJ
Occupation
Real Estate Appraiser/Broker
Mine did this one Monday. I took it to the dealer and it magically was fixed. They said they didn't do anything; however, the plug and harness on the rear end had obviously been unplugged and cleaned and the plugged back in since they were perfectly clean and everything else wad dusty.
After the dealer "fixed it" the light started flashing again on Saturday. I think the dealer just reset my computer somehow if that is possible. The electronic settings in my Jeep were all reset and the "Offroad Pages" option wasn't even there until if magically reappeared after driving for 10-15 minutes.
 

Jaxmax

Well-Known Member
First Name
Jack
Joined
Jun 28, 2020
Threads
54
Messages
2,856
Reaction score
4,637
Location
Bally, Pa.
Vehicle(s)
Jeeps....... 2021 Mojave , 2019 Wrangler
Occupation
Electrical Manager
Mine has been that way since about 95 miles, or been on for over 15,000. Check your rear locker, all the lights on dash should light up and also check if you can lock it in 4 High…..Jack
 

PDiddy

Well-Known Member
First Name
Paul
Joined
Aug 17, 2020
Threads
14
Messages
811
Reaction score
1,969
Location
Roseville
Vehicle(s)
2020 Jeep Gladiator Rubicon
Occupation
Architectural Illustrator
I’ve had my bypass plug in for about a year now. Last weekend the light started blinking again. Went under the truck to take a look and found the red positive wire from the bypass was worn and broke in two. I had to solder the wired back together. I like the bybass, but the whole harness hangs from the two tiny positive and negative wires. It really needs a sleeve over the two bedroom it’s going to the plug. I taped them up and tried to secure the assembly better, so it doesn’t vibrate and wear out the wires again.
Sponsored

 
 







Top