Gladiator Mojave with Rubicon Off Road steel bumper

[DbMojave21]

question. I did get the bumper and winch today. If you did or did not lift your truck, how much did you front end sag down with the Rubi bumper and winch? i think between the 2, it's probably 250lbs weight.
I measured out and seems about 1/2" front end is less than rear as it sits stock.
my debate was if i should go with skyjack spacer lift as they provide an extra 1" lift in the front, which would probably put the jeep at level. thoughts?

Sponsored

 

[Bulldog4xfour]

I have the steel bumper on my Mojave and Rubi skid so that I didn’t have to cut anything. So far I’m loving the look. I don’t have a winch yet, but I’m thinking about using the teraflex spacer when I do. I had it on my JL and really liked the quality of it.

 

[Montana_Wildcat]

I'm thinking of either the Mopar steel or the Arcus. Have any of you seen a big difference in front ride height (has the rake increased much?) or actual ride?

 

[DbMojave21]

I'm thinking of either the Mopar steel or the Arcus. Have any of you seen a big difference in front ride height (has the rake increased much?) or actual ride?

I haven't put my on yet.. planning on it this weekend. but i'm about 240.. and me leaning on the entire front bumper, it seems it drops about half an inch.

 

[DbMojave21]

Ok.. a little stuck on this bumper. Seller didn't send the right stuff and cover came in damaged. Started the install today with the winch, and I'm baffled what all the brackets are, that are included with the kit. Does the winch plate only mount in the front? .

Sponsored