Search results

Thank you all for your replies. I ended up installing Synergy 1.75" (5x5) spacers. Worked perfectly and no need to trim the wheel lugs.

I have a 2022 JT Sport with the original 'black' stock steel rims, and am looking to touch up some scratches. Though it looks black (Mopar PX8), it is really a very dark grey (not unlike some undercarriage paint). Does anyone have either the paint code, or a recommendation for a good...

Hi Ed, I have a very similar set up: Jeep Sport (non-MaxTow), upgraded tires (35" MT Baja Boss AT), 1.5" Teraflex leveler kit. I just added the Teraflex quick disconnect kit. That kit is good for 0-4.5" (or 0-6" depending on which literature you reference). Based on my experience, this...

Spacers (Synergy 5x5 1.75") resolved the suspension rub, though I did need to trim a 1/4" off of a small section of the plastic front air dam.

I considered that, and I think it could have worked on the driver's side, but the geometry on the passenger side didn't look like it would work right.

Thank you. The axle is centered, as I have near equal rub at full right and left turn. Spacers are going on today to see if that resolves it.

Thank you.

I see this is an older thread, but I have the same question with a follow up. If the answer is 'no', then what is thick enough? (1.75"?) I have factory steel rims on this 2022 Gladiator Sport. What is the minimum thickness spacer allowed with factory steel rims? What did you get JeffreyDV?

That is how I roll . . . replaced the factory ATs with Mickey Thompson Baja Boss LT255/85R-17. Still running the factory Sport black steel rims 3 1/2 years later.

Step one done - Sway bar disconnect installed. Before: No rub. After: rub introduced on full left and right turn - contact at the widest portion of the inside sidewall (at the tire lugs "mud teeth") and the joint knuckle for the sway bar connect when connected. No fender rub issues (yet). I...

Ugh, I wish I saw your post before today. I have a 2022 Jeep Gladiator Sport (JT). The suspension is stock other than three modifications, which are, in the order they were installed: 1. Mickey Thompson Baja Boss AT LT255/85R-17 (on original stock rims) 2. TeraFlex 1155300 JT 1.5”...

I can let you know soon . . . I am installing the disconnects this week and going to Stony Lonesome next month. I do know that that the Teraflex leveler kit included new bump stops, so I'm thinking we'll be okay. Stay tuned...

You are describing a set up very close to what I run. I do go off-road a few times a year, but most of the miles are on road. I have a 2022 JT Sport, non-maxtow, stock rims (17", 7.5" width), no spacers, Mickey Thompson Baja Boss AT 255/85R/17. One variation from your request is that I have...

Last year, I was at the hospital with a critically ill family member. It was a particularly difficult time for us. One night, after being there for 36 hours, I was greeted with a duck on the door. That small thing really helped in that moment. A few days later, I saw this bright pink Wrangler...

There was a 'Customer Satisfaction Notice' (i.e., voluntary recall) on the tailgate actuator. I do not know if it applies to power or just manual locks, but it might be worth checking out for your ride. The recall number is 'ZE2'

Okay, I am going to say it. I don't have an issue with the ducks. I remember the first time I got one and I was genuinely pleased at the gesture. Over the years I got a few more, and honestly I can tell you when and where each one arrived. I keep about a half dozen on the dash, and one...

Yes, some GMRS radios can broadcast an ID as either a recorded voice message, or in Morse code. GMRS CWID (Continuous Wave Identification) is a system where a GMRS repeater transmits a unique Morse code signal to identify itself periodically to comply with FCC regs. These are typically used...

This is not an uncommon issue. My 2022 JT Sport has similar behavior when sitting for more than a few days. Here is what happens. State: There is a very slight vacuum leak either in the vacuum booster, the check valve grommet , or the check valve at the port where the vacuum is supplied to...

Regardless of if there is a digital signature on the radio (that's not a thing for the GMRS specification), the FCC license registration only associates the license owner by name to a call sign. Radios are not explicitly registered with family GMRS licenses. (The radios themselves must be FCC...

I do more challenging wheeling about 1-2 times per year. I have a Midland MXT275 mounted inside, and a MXTA26 6DB Gain Whip Antenna outside. When not wheeling with a large group or in remote areas, I store the antenna and radio under the back seat. (The MX275 is rather compact and is mounted on...