Search results

If you have the aux switch group there is a battery hot wire in the cab. You could easily wire in a plug always hot.

Q on the lights; what would the eas way of setting them up to come on with the regular reverse lights and with an aux switch be? Can I just add a hot line and force them and the trucks rev lights on? I’m thinking that might cause an issue w the trucks brain.

No cut it off, your aux switch is twice as nice and a clean install vs fishing a line and adding there switches to your dash.

YA he would have over heated 1/2 up and that motorhome would have had to tow him up the grade.... :CWL: :bandit:

There is a frontal area restriction in the spec sheet. Al I can say.

Before;

2104s? GVWR 6774. You are looking at a smaller unit (good!), slide is centered on the axles, good, looks like a nice little unit. If your stock, no lift, no 37's etc then yes I would tow that trailer with your ride. You will need to be mindfule your trucks payload, keep things in the...

Wires! Harness for the cowl lights came, got that run. I cut off apx 5' of it, the harness from Diode Dynamics is set up to run a switch, as I'm using the factory Aux switch I was able to just chop off the switch section. Not a lot to see here as the lights have not shown up. Simply ran the...

After measurements: Rear call it 39 13/16" started at 39 3/16" net rear apx +5/8" Front call it 38 3/4" started at 37 1/4" net 1.5" on the dot.

Lots happened today! Front spacer 1.5" teraflex and the daystar rear 3/4" with the Mopar replacement control arms, front, from the 2" lift kit done. As well as an alignment, was very close to spec. So the "lift" kit is done. What I wanted was just a little more height over stock, with the...

OP, really not enough information to give you an answer. What trailer are you looking at? What physical size is it? Long, width? What are it's gvwr numbers? A 7000 pound loaded 7' wide 16' long box trailer will be different than a 28' long 8' wide travel trailer of the same weight. A 5100...

So far so good, I only have couple hundred miles on them. I wanted a little taller than 33 but not 35's, snow rated with good road handling, hence the AT compromise. I've had them in the past (other rigs) and liked them. I got the C rated vs the E, just don't need the E load rating on this...

Fix your slush mats, the plug should be pulled from under the carpet and the carpet cut out (it's pre done at the factory), that plug then goes on top in the mat cut out. The dealers do not install the correct.

Ya the hood badge was obnoxious lol. Came off the first day.

Front Rear More tomorrow!

Yes it's part of the 4 auto system. And it's awesomeness! I have it also ?

Light brackets in, really like them, simple good looking. Lights end of the week!

I'm sure it was some yack a$$ in a parking lot. I bet red lock tight would solve the issue, for that.

Long did you use this mount? I got them but don't think they are for JT's, the wind shield bolt dose not mate up to this? Or I'm missing parts from the kit.

I bought this off amazon kinda on a whim and I am totally impressed. Way better quality than the 1" straps I had from HomeDepo/Auto parts stores. Nice loops included, great mechanicals. Liked them so much I bought a second pack...