AEV Borah wheels with 3.5” Clayton lift?

[21Mojave24XR]

I have done search upon search trying to figure this out so it’s not from lack of trying! Has anybody ran this setup, I want to keep it as tucked or flush as possible. I have a Mojave with 3.5” Clayton lift with all control arms and falcon 3.3s and it does see trails but in my area there ain’t anywhere for it to see max articulation, most flex it sees is washouts. So just trying to figure if the borahs at +25 is going to work and not rub even if I do step up to 37s.

any help is appreciated

Sponsored

 

[Pickle_Bill]

I have the clayton 2.5" with Method +25. My 37" MT-02's barely (and I mean barely) rub my front lower control arms at full lock. It's fine for me as I like the minimal poke with the +25 offset.

Edit: the clayton 2.5 and 3.5 have the same control arms. Only difference is the springs.

 

[Flyin6]

I have the Clayton 3.5" overland lift and the Bora bead lock wheels...It all fits fine!

 

[21Mojave24XR]

Awesome, thank you to you both. I have been wracking my brain for months trying to find the right wheels and what offset etc etc. My brain went into full analysis paralysis and didn’t want to buy them to figure out they wouldn’t work as they are not exactly cheap with the beadlock or protection rings included. When I step up to the 37s it will be the MT02s again and if need be I can throw a washer in behind the steering stop

Again it is greatly appreciated

Sponsored