Baja Design LP6 question

[microboby]

One last question- I am thinking of same mopar winch and light position as you have. I will go for LP4s. No problem fitting your LP6s in that slot? Before I saw your pic I didnt think there was room. No regrets with that mounting position vs putting on the winch bar? THanks

I could actually fit LP9’s in the same setup , would have look cool . Think Lp6’s are just fine but def they don’t look huge . I ordered a set of lp4’s a while ago to add to A pillars on white as a spot pattern . My bumper is the Amazon $460 bucks and it’s fits the lights perfect . I believe if you decide to not install the winch bar then you have another morning option for the lights because the holes the guard takes but I like the bar and it came with the bumper . My advice would be stick with lp6’s anything smaller might be look to small

Sponsored

 

[sauron2001]

Hello microboby please can you tell me which manufacterer sells this model of hoop? It seems the Mopar hoop but i bet it isn’t as i’m checking and it seems not. Thanks!

[/QUOTE]

 

[Commodus]

Hello microboby please can you tell me which manufacterer sells this model of hoop? It seems the Mopar hoop but i bet it isn’t as i’m checking and it seems not. Thanks!

[/QUOTE]
That definitely looks like a Mopar winch guard since I don’t know any others that sit that low

 

[Ware]

I got them but only wired the hi beams , waiting on that VOswitch to complete the proper wiring modes . Here’s how they look

@microboby could you post a side view photo? I would like to see if or how far the lights hang past the front of the bumper. Thanks in advance!

 

[LostWoods]

@microboby could you post a side view photo? I would like to see if or how far the lights hang past the front of the bumper. Thanks in advance!

The LP6 are thin and shouldn't protrude forward much. I think they're at most about 1.75 inch forward of the bolt hole so you can measure where you're mounting them to see where they align.

Sponsored