LANGeek
Well-Known Member
- Thread starter
- #1
I installed the Bestop Supertop on my 2020 Jeep Gladiator.
The directions are OK. They leave you to figure out a lot. They are basic "stick figure" drawings. It would be nice to see color photos.
The top does not fit well. There are gaps in the front that will suck in wind, rain, road debris, and other stuff. The gap is about a ÂĽ of an inch between the rail the bed.
One of the tabs that holds the rear corn in place will not stay in position. This will allow updrafts from the rear to bring water and debris into the bed. Plus, over time the flapping will wear that edge.
The bars that attach the driver and passenger bows do not fit together correctly. They have spring loaded connectors that just simply do not line up. The bows can be pushed closer without them. The top could sag in the right wind conditions or the weight of snow.
I trying to return it. Overall I would say this top sucks and is not worth the time or money.
The directions are OK. They leave you to figure out a lot. They are basic "stick figure" drawings. It would be nice to see color photos.
The top does not fit well. There are gaps in the front that will suck in wind, rain, road debris, and other stuff. The gap is about a ÂĽ of an inch between the rail the bed.
One of the tabs that holds the rear corn in place will not stay in position. This will allow updrafts from the rear to bring water and debris into the bed. Plus, over time the flapping will wear that edge.
The bars that attach the driver and passenger bows do not fit together correctly. They have spring loaded connectors that just simply do not line up. The bows can be pushed closer without them. The top could sag in the right wind conditions or the weight of snow.
I trying to return it. Overall I would say this top sucks and is not worth the time or money.
Sponsored