Cajun4X4
Active Member
- Thread starter
- #1
Finally bolted up my new bumper and winch. Really happy with the way it looks. The winch sits really low and barely blocks any of the grill. Its a tight fit between the grill and the back of the winch, but I think I can move the wires around to add some clearance.
Install was pretty straight forward. Although tearing down the plastic bumper to get the fog lights was time consuming. Just a lot of small fasteners. The eight bolts holding the bumper to the frame are A PAIN to get started. An air or electric ratchet is must for the install, since there is no room to move regular wrenches. I used a pick up magnet to help position the washers and nuts. The Rubicon skid plate fits with no modifications too. Only thing I couldn't reuse were the red tow hooks.
Just need to finish the wiring for the winch and decide on some aux lights.
Install was pretty straight forward. Although tearing down the plastic bumper to get the fog lights was time consuming. Just a lot of small fasteners. The eight bolts holding the bumper to the frame are A PAIN to get started. An air or electric ratchet is must for the install, since there is no room to move regular wrenches. I used a pick up magnet to help position the washers and nuts. The Rubicon skid plate fits with no modifications too. Only thing I couldn't reuse were the red tow hooks.
Just need to finish the wiring for the winch and decide on some aux lights.
Sponsored
