Low profile front bumper

[Cbieh589]

Anyone have any suggestions for a low profile front winch capable bumper? I would like something that doesn't stick out very far but I'm still able to mount a winch, I've been looking at the AEV bumpers but they are spicy in the cost department. Full width is appreciated and preferred but all suggestions welcome. Thanks!

Sponsored

 

[MarkN]

Look at Addictive Desert Design in Arizona.

 

[j.o.y.ride]

Any stubby should do. Just decide things like high or low winch mount, fogs or no fogs, no bar bull bar or stinger. But know that low mount and fogs is hard to or impossible to fine in stubby. I like my Motobilt low mount no fogs and bull bar.

 

[SteveInOrlando]

It doesn't matter what you get. The reason the bumpers stick so far forward is the frame horns are so long. I took a steel rubicon front bumper and removed the crush cans, it only sticks 1 inch pas the front of the frame horns. That means it is only 3 inches shorter than stock.

Unless you shorten the frame horns, you will have a bumper that sticks out a long way in the front. Just get used to it.

 

[OffroadAlliance.com]

We have the Bondi Deluxe Winch Bumper in stock if you're interested. ARB is a great brand and the bumper is under $1,000.

 

[Hipbilly]

Frame chop time!!

Kevin & Chris of LiteBrite [studios?] just finished a good one on their JLU.... this is about as good as it gets right here.

FRAME CHOP ON A JEEP WRANGLER JLU RUBICON! - YouTube

 

[Cbieh589]

We have the Bondi Deluxe Winch Bumper in stock if you're interested. ARB is a great brand and the bumper is under $1,000.

Could you link to that? I went on your website and couldn't find it. I would be interested though.

 

[WILDHOBO]

Could you link to that? I went on your website and couldn't find it. I would be interested though.

Low profile integrated stealth winch mount, full width, 12k winch certified, not very heavy at approximately 80lbs. Works great. I’ve used the winch a bunch of times. Couldn’t be happier. Warn Elite Full Width. 101335. Warn sway bar disconnect skid plate. 101445. 37’s fit great. Minimum 2” lift for 37’s. They also make a stubby, but you asked for full width, which I have. They also have a bull bar, but I didn’t want one.

 

[OffroadAlliance.com]

Could you link to that? I went on your website and couldn't find it. I would be interested though.

Sure! Just PM'd you

 

[SteveInOrlando]

Frame chop time!!

Kevin & Chris of LiteBrite [studios?] just finished a good one on their JLU.... this is about as good as it gets right here.

FRAME CHOP ON A JEEP WRANGLER JLU RUBICON! - YouTube

Wow, they chopped the frame horns right off that jeep!

Interesting bumper they fit over it to still fit a winch. That has to improve approach angle.

Sponsored