Mopar LED fogs on Sport S not working

[ImThe0ne]

I installed a Steel Rubicon bumper w/ Mopar LED fogs & the matching wire harness and can't seem to get the fogs to work. I've Activated all of the settings for LED Fogs I could find in JScan, restarted all ecus after it successfully applied and I get nothing on the fogs. At one point there was a code on Jscan claiming the fogs circuit was "open" but that has since disappeared.

Would your first thought be a bad harness maybe or am I missing something? The halogen fogs worked fine but I left them in the bumper as I was moving to all LEDs.

Sponsored

 

[BaliMawr]

Not sure, but I did have the experience of swapping out a bumper on a '20 JK, and the fogs didn't work. Then after turning it off and on again, they did. Like an old PC.

 

[ImThe0ne]

Not sure, but I did have the experience of swapping out a bumper on a '20 JK, and the fogs didn't work. Then after turning it off and on again, they did. Like an old PC.

Unfortunately this has been going for about 2 months, I’m just lazy and just now getting around to asking for help. ??‍So I’ve turned it on and off a lot, disabled the setting with JScan, renewables, etc multiple times since install.

Guess my next move is to hook up the old fogs and make sure they will still turn on.

Sponsored