New alignment results

[double J]

I have a Jt Rubicon, with mopar lift, and 1” spacer. I also added metalcloak front and rear adjustable trackbars, and front upper control arms. It was aligned today. Shop wanted to stay at factory 4.80 castor, told them I would like it closer to six. Could you give me your opinion on the results.

Sponsored

 

[CaptNkllm]

Assuming you left already? How’s it drive and respond?

 

[double J]

Assuming you left already? How’s it drive and respond?

It seems ok, need to try it on interstate closer to town. The roads are crap there. Before I added the track bars,and control arms, I would notice bump steer there. After adding those parts I thought it should get another alignment.

 

[double J]

Assuming you left already? How’s it drive and respond?

It drives ok. I’m just not sure about the alignment sheet, and the toe. It reads total toe -0.05, that is toe in , right?

 

[CrazyCooter]

It drives ok. I’m just not sure about the alignment sheet, and the toe. It reads total toe -0.05, that is toe in , right?

Looks good to me! You were even lucky enough to get a little caster lead to the left. The -.05° toe looks to be the before reading....If you look at the after reading and do the math, it comes out to +0.11°.

 

[double J]

-05 is total toe.
after is
Left -0.04
Right -0.01

 

[CrazyCooter]

-05 is total toe.
after is
Left -0.04
Right -0.01

Yep, I see that now. Why did they send it out with toe out?

Wonder how much error is in that machine too? I did it old skool with bubbles and tape measures, so no error unless someone came in hung over.

 

[ShadowsPapa]

Yep, I see that now. Why did they send it out with toe out?

Wonder how much error is in that machine too? I did is old skool with bubbles and tape measures, so no error unless someone came in hung over.

Toe out only used with front wheel drive or full-time 4 wheel drive.
I can't see these ever being toe out.

 

[CrazyCooter]

Toe out only used with front wheel drive or full-time 4 wheel drive.
I can't see these ever being toe out.

Tech just lazy?

 

[double J]

Yep, I see that now. Why did they send it out with toe out?

Wonder how much error is in that machine too? I did is old skool with bubbles and tape measures, so no error unless someone came in hung over.

I showed them the mopar lift specs. They may have mid read toe In. (0.0 - 0.12). The sheet looks like 0.0 -0.12)

 

[double J]

Had the toe adjusted.

Sponsored