OEM Auto Light Switch install?

[Steve JAK]

Thanks for the help, guys. I let it sit for the weekend, and they are working now, but the sensor is so sensitive that a shadow is activating my lights. Does anyone know how/can adjust the sensitivity? For anything to take effect, we have to cycle power, right? I'm fairly certain I did that, but I can't remember. I think I forgot to do that, and that is why they were working.

Sponsored

 

[Hootbro]

Does anyone know how/can adjust the sensitivity?

 

[Steve JAK]

Thank you.
Should I lower the voltage or raise it? I don’t know which way would make it less sensitive.

 

[Hootbro]

Thank you.
Should I lower the voltage or raise it? I don’t know which way would make it less sensitive.

No clue. Just play around with the settings and cup the sensor to figure out which way to go.

 

[Capt Curt]

Sun Sensor = 68230114AB Light load sensor for HVAC and Auto Headlights Avoid 68230115AB which is HVAC only.

Headlight Switch = 68542459AA is the one with the auto setting, Avoid 68542460AA it is the one without you already have.

enabled JScan -> Adaptation -> Auto Headlamp & Auto High Beam - Settings -> Auto Headlamp Feature Present On/Off, - Target Value = Active.

enable JSCAN -> Modules -> Body Controller -> Configuration -> Headlamp on with wiper customer settings menu -> Set
(not sure if actually needed but go ahead and turn it on so you can on/off it from the Radio rather than have to jump through JSCAN Menus)

@webduelist - Brother, this worked like a champ! I ordered the part numbers listed, followed the JSCAN menu and, boom, auto headlights. Super easy upgrade the way you've got this outlined. It probably only took 15-30 minutes (once I finally got the bypass cables connected, LOL). This is the most useful mod we've made so far and the wife loves it! Thanks for making this post!

 

[webduelist]

@webduelist - Brother, this worked like a champ! I ordered the part numbers listed, followed the JSCAN menu and, boom, auto headlights. Super easy upgrade the way you've got this outlined. It probably only took 15-30 minutes (once I finally got the bypass cables connected, LOL). This is the most useful mod we've made so far and the wife loves it! Thanks for making this post!

Thanks, Make sure to check out my write up on OEM Remote Start, which is also extremely easy now that all the piece parts have been figured out.

 

[JeepNightHawk]

Thanks, Make sure to check out my write up on OEM Remote Start, which is also extremely easy now that all the piece parts have been figured out.

Glad to see webduelist still here. He is very knowledgeable. I installed automatic headlights and the remote start was just as easy.

Sponsored