Sponsored

ParkSense stopped working

saintpauljeff

Well-Known Member
First Name
Jeff
Joined
Dec 5, 2017
Threads
15
Messages
637
Reaction score
435
Location
South Minneapolis, MN
Vehicle(s)
'21 Gladiator Rubi, '03 BMW Z4, '20 Mitsu OutSport
Occupation
Software Developer
Went through touchless car wash to clean salt off truck. When leaving my destination an hour later, the ParkSense feature emitted a long solid beep when I went into reverse. Reading a little bit about this, the suggestion is to clean off the sensors on the bumper? Anyone do this before, just a matter of wiping the underside of the rear bumper?
Sponsored

 

am1978

Well-Known Member
First Name
Adam
Joined
Jun 26, 2018
Threads
33
Messages
1,362
Reaction score
1,196
Location
MD
Vehicle(s)
2021 JTRD, 2018 JLU Sahara
Occupation
Homebrewer
Went through touchless car wash to clean salt off truck. When leaving my destination an hour later, the ParkSense feature emitted a long solid beep when I went into reverse. Reading a little bit about this, the suggestion is to clean off the sensors on the bumper? Anyone do this before, just a matter of wiping the underside of the rear bumper?
Did a wire connector get dislodged from the undercarriage high pressure spray stream? Be careful with those sensors. They are not very durable and the slightest alignment issue can cause you headaches.
 
Last edited:
OP
OP
saintpauljeff

saintpauljeff

Well-Known Member
First Name
Jeff
Joined
Dec 5, 2017
Threads
15
Messages
637
Reaction score
435
Location
South Minneapolis, MN
Vehicle(s)
'21 Gladiator Rubi, '03 BMW Z4, '20 Mitsu OutSport
Occupation
Software Developer
Wiped off the entire bumper this morning and all is well, it’s working again. I swear those sensors were not that dirty. Guess the system is overly sensitive to the slightest debris ?‍♂
Sponsored

 
 







Top