Push Button Start Does Not Illuminate

[bluerig]

On my push start button, the OFF, ACC, RUN do not illuminate. I replaced the ignition switch module and the new one is also not illuminating. I just sometimes can't tell if I'm in ACC or RUN. I've wondered if it's a fuse or something. Any ideas?

Sponsored

 

[Lunentucker]

Possibly something useful here
https://www.jeepgladiatorforum.com/...-push-button-start-button-not-changing.68880/

 

[bluerig]

Possibly something useful here
https://www.jeepgladiatorforum.com/...-push-button-start-button-not-changing.68880/

Thanks. I checked all the fuses. Nothing wrong there. Can't figure what's the issue.

 

[kemosabe]

Hi, have you figured out the issue that you have? My start button just went off today. no illuminate light (RUN / ACC) at all but gladiator is running as normal. Thanks
Let me know if you have to take it to dealer for service. Thanks

 

[bluerig]

No luck at all. I replaced the entire ignition switch and still doesn't light up. Please let me know what the dealer says. I'm at a total loss on this one!

Hi, have you figured out the issue that you have? My start button just went off today. no illuminate light (RUN / ACC) at all but gladiator is running as normal. Thanks
Let me know if you have to take it to dealer for service. Thanks

 

[Vtur]

You have any device connected to the obd2 port?

 

[ecidiego]

Is this a thief trying to figure out someones kill? Sorry....new user and all....

 

[bluerig]

You have any device connected to the obd2 port?

No device connected to obd. What are you thinking?

 

[XjBilly]

Just had this eact problem fixed on my Gladiator. It was the Hub Frequency Module in the rear driver-side interior trim panel near the rear speakers !! Hope this helps anyone with the same issue

Sponsored