Install of 813 Fabrication's New Underhood ARB Compressor Mount

[same_O_G]

Hey All,

Thought I would do a quick review of the new @813 Fabrication & Design underhood mount for the ARB single compressor.

I posted in another thread that I was looking for an ARB compressor mount that would work with the 2022+ JTs that have the newer computer bracket. Jeremy, the owner of @813 Fabrication & Design, responded and he and I had a back and forth through DMs. He told me that he had a new bracket design in the works and offered to sell me one of his prototypes (at time of writing, these aren't yet available on his site). I shot him payment and it was in the mail next day.

Install was pretty straightforward. He didn't have any instructions written up yet, but he sent me a bunch of photographs that laid it out pretty clearly (and it's seriously only a few bolts).

I got everything wired up and finalized this afternoon and am very happy with the end result. The bracket is super solid and looks very clean. I can't speak to the other hoods, but I get no contact/rubbing with the Mojave hood.

If I could do it all over, I would have wired the ground for the compressor under the bracket instead of over it (because I have OCD), but that's nothing against the bracket at all, just how I wired the compressor.

Anyway, check out the photos. The prototype is raw aluminum, but Jeremy said the final version will be powder coated black.

(I'm not affiliated with 813 and I paid for the prototype.)

Sponsored

 

[813 Fabrication & Design]

Hey All,

Thought I would do a quick review of the new @813 Fabrication & Design underhood mount for the ARB single compressor.

I posted in another thread that I was looking for an ARB compressor mount that would work with the 2022+ JTs that have the newer computer bracket. Jeremy, the owner of @813 Fabrication & Design, responded and he and I had a back and forth through DMs. He told me that he had a new bracket design in the works and offered to sell me one of his prototypes (at time of writing, these aren't yet available on his site). I shot him payment and it was in the mail next day.

Install was pretty straightforward. He didn't have any instructions written up yet, but he sent me a bunch of photographs that laid it out pretty clearly (and it's seriously only a few bolts).

I got everything wired up and finalized this afternoon and am very happy with the end result. The bracket is super solid and looks very clean. I can't speak to the other hoods, but I get no contact/rubbing with the Mojave hood.

If I could do it all over, I would have wired the ground for the compressor under the bracket instead of over it (because I have OCD), but that's nothing against the bracket at all, just how I wired the compressor.

Anyway, check out the photos. The prototype is raw aluminum, but Jeremy said the final version will be powder coated black.

(I'm not affiliated with 813 and I paid for the prototype.)

Thanks! I'm glad you like it and the install went well! I am working on instructions and should have them on the site this week!

 

[kevman65]

Jeremy, will it work WITH the engine cover, or only the nekkid engines?

 

[813 Fabrication & Design]

Jeremy, will it work WITH the engine cover, or only the nekkid engines?

I believe it may require a small amount of trimming on the cover if you want to keep it on. I have been developing it with out JLU that does not have the cover. I need to test it yet with my Gladiator that has the cover. I have the Genesis dual batteries also.

Sponsored