Wow ok, I’ll look. These harnesses are garbage.
It’s the passenger side door. You were right, there was a bent pin.
Did you isolate which one it was by watching the dash for the open door icon?
I believe someone here has done that very thing - changed connectors.
We've found out that icon doesn't always show - depending on how open the door is.
yes that’s exactly how I figured it out. The red door open icon did not show when I opened the passenger door.
I may grab some new molex connectors and do that if this continues to be an issue.
There is an array of things that will or wont work depending on what pins are bent.
If so equipped, BSM disabled is one of the errors. Otherwise, I've seen basics like remote mirror, door locks, windows, any combination of things, like you already mentioned.
Nice. Take good pics and document your trials if you don’t mind. This is also on my to-do listI am engineering a replacement door connector system. It is the Aptiv (formerly Delphi) HES connector system. The are round with a quick disconnect type of slip ring. It has all three of the wire/terminal sizes that the original has. The male end is panel mountable with a nut so hopefully connecting and disconnecting can be done with one hand. I don't have all the parts yet but I believe it will fit under the Jeep's original connector cover.
I will also have all the individual components of the original door connectors. The male & female connector housing halves, both male and female crimp on terminals all three sizes of the wires used in the connector.
