California 1/4" or 3/8" steel plate bumper spacers

[svc707]

Any interest in spacers to push out your bumpers for clearance issues? I made these to push out my bumper to relieve some of the contact I had using the Arcus front bumper package and the HF Bandland Apex winch. I went off the bolt pattern from the supplied hooks (which are not equally spaces) but I will make the holes larger to allow for more adjustments.

*updated this post 6/30/2024*

I’ve gone back and forth on what to offer and decided to use 1/8” plates so end user can dial in as needed. It’s is more work on my end but I’d rather give options to adjust since there’s so many bumper designs and who’s using what winch.

4 total plates = approx 1/4” (2 per side) $40 shipped
6 total plates = approx 3/8” (3 per side) $50 shipped

Thanks
Steve

Sponsored

 

[Hootbro]

I would be down for a set.

 

[svc707]

Just finished three pairs ready to ship. PM me for more details and I'll ship out tomorrow.

Thanks
Steve

 

[svc707]

1 more pair available. I'll cut more next week.

Thanks,
Steve

 

[Vballer16]

Im interested in a set. i have the same bumper. Did you actually put the plates on the outside of the winch plate?

 

[svc707]

Im interested in a set. i have the same bumper. Did you actually put the plates on the outside of the winch plate?

Yes. I put after winch mount. Between winch plate and hook plate.

 

[svc707]

I cut 6 more pairs.

 

[Hootbro]

Just a friendly plug that I got my set from svc707 within a week on the opposite coast. As pictured, very well packed and great quality.

 

[svc707]

More sets ready to go

 

[svc707]

PM for more details. I have 4 sets left from this run ready to ship.

 

[svc707]

Plates are ready to ship. ?

 

[KB34]

Plates are ready to ship. ?

I’m down for a set.

 

[svc707]

Bump....

 

[svc707]

Bump...

 

[atxatxatx]

I'm down for a set,

Sponsored