remlemasi
Well-Known Member
- Thread starter
- #1
Replacing a damaged rear driveshaft with a stock MOPAR one and need torque specs for the 8 bolts on each end of the driveshaft.
I see 80 ft-lbs thrown around a lot for upgraded driveshafts, but I those use larger and less bolts for the u-joints. No idea for the stock cv-jointed flanges on mine.
EDIT: I think I found it over on the JL wrangler forum. Lots of other torque specs there too: https://www.jlwranglerforums.com/fo...for-jeep-jl-wrangler.17791/page-2#post-518096
I see 80 ft-lbs thrown around a lot for upgraded driveshafts, but I those use larger and less bolts for the u-joints. No idea for the stock cv-jointed flanges on mine.
EDIT: I think I found it over on the JL wrangler forum. Lots of other torque specs there too: https://www.jlwranglerforums.com/fo...for-jeep-jl-wrangler.17791/page-2#post-518096
Sponsored
Last edited: