Lets see your wheel poke

[md_adirondacks]

I'm really curious to see how much wheel poke there is with various wheel and tire combos.

I'm strongly considering Black Rhino Kelso wheels that are 9" wide and 0 offset along with moving to 315/70-17 tire but I did some math and I'm afraid that would poke out too much for my taste.

So if you have pics of your wheel poke, post them up!

Sponsored

 

[j.o.y.ride]

Shouldn't stick out too much. If you really don't want any then go with 11.5 or even 10.5 instead of 12.5

 

[Moe_Fugga]

17x9 -12 offset 35/12.5

 

[md_adirondacks]

I'll start, this is it stock right now. No poke at all. I'm fine with some, this IS a Jeep after all

 

[tbaker]

17x9 Dirty Life Wheels with -12 offset running 37 inch milestar Patagonia tires

 

[A 2]

BFG 315 70 17 on KMC roswell 17x8.5 +18. Installed yesterday.

 

[adentmon]

35x12.5 Goodyear Wrangler ultra terrains on 20x9 KMC Mesa wheels, +18 offset

 

[Terminus33]

So if you have pics of your wheel poke, post them up!

 

[md_adirondacks]

BFG 315 70 17 on KMC roswell 17x8.5 +18. Installed yesterday.

Thanks! Seeing this pretty much solidified that original choice my 9" wheel with 0 offset would have been just a little too much for me.

Looking good!

 

[07052021]

BFG 315 70 17 on KMC roswell 17x8.5 +18. Installed yesterday.

Beautiful. Any lift, leveling, or spacers?

 

[A 2]

Beautiful. Any lift, leveling, or spacers?

Nada. I checked full lock and looks good. Haven’t disconnected my sway yet. I’ve got a really steep funky driveway, almost like an articulation ramp. I will mess with it this weekend. I don’t want to do anything suspension wise until there’s resolution on this diesel bottom out issue I keep reading.

 

[A 2]

Thanks! Seeing this pretty much solidified that original choice my 9" wheel with 0 offset would have been just a little too much for me.

Looking good!

If you want the treads to stay under, its perfect. obviously the side wall extend past. I did notice on the driver side the treads are out about 1/4-1/2” might be steering turned a bit or the angle I was looking. No lift.

Sponsored