Mopar Performance Wheels 77072494AB

[2021Willys]

I have a 2021 Willys Gladiator with the Mopar Bilstein 2” lift. I want to purchase the Mopar slotted performance wheels 77072494AB and run 37x12.5x17 BFG K02s. The wheels are 8.5” in width with a +12mm offset (5.22 inch backspace). Do you think I will have any issues rubbing on the front lower controls arms? Thanks

Sponsored

 

[Vtur]

My Overland (same width axle) with 17X8.5 +4MM and 37x12.5 tires cleared the lower arms by 1/2-3/4in on full locks. You can add a washer under the stopper too if needed.

 

[Stan H]

I have a 2021 Willys Gladiator with the Mopar Bilstein 2” lift. I want to purchase the Mopar slotted performance wheels 77072494AB and run 37x12.5x17 BFG K02s. The wheels are 8.5” in width with a +12mm offset (5.22 inch backspace). Do you think I will have any issues rubbing on the front lower controls arms? Thanks

+12 or -12 ??

 

[2021Willys]

+12 or -12 ??

+12mm. I’ve seen a few Rubicons with those wheels on 37” tires but the Rubicons have slightly wider axles. I just want to know if they will rub on the narrower axles.

 

[Stan H]

+12mm. I’ve seen a few Rubicons with those wheels on 37” tires but the Rubicons have slightly wider axles. I just want to know if they will rub on the narrower axles.

Dunno I gots the wider ones. Can't help.

 

[Gizmo]

I have no rub any place but I also have the wide axles with the same tires

 

[Dog Dad]

Those are nice rims.I thought about purchasing 4 for mine but over here in Canada they run about $ 1800. for 4 rims and depending on the tire it's pretty pricey.

 

[2021Willys]

I have no rub any place but I also have the wide axles with the same tires

They look great. Are those 35” or 37” tires? When you are at full turn how close are they to rubbing the control arms? Thanks

 

[Gizmo]

Looks like they have gone up here in the states also. The tires are 37” KO2’s. I will check during the day. I have Metalcloak arms but they didnt rub when I had MOPAR arms either. I also have Currie high steer which also gives me new knuckles with adjustable stops in both directions. That said my measurements may not tell ya anything. I did not rub with the OE knuckles either

 

[Gizmo]

They look great. Are those 35” or 37” tires? When you are at full turn how close are they to rubbing the control arms? Thanks

I measured today while installing new shocks. About 3 “ away from MC arms

Sponsored