Rockslide Engineering step HELP!

[immaechu]

So I was undoing the body mount bolts. The rear and front were easy enough for me to slide the bracket in. As for the middle... The bolt was able to unthread but the washer hole seems too small and would get stuck right before the threads leaving me with only like 2 mil of space. And not allowing me to slide the bracket in.

Should I just take the bolt out completely and figure it out? or force it between the washer and bolt by hammering it in?

kinda stuck.....

please help.

Thanks

Sponsored

 

[hjdca]

If I understand you right, the washer is too close to the bolt head. Rockslide says to take a small file and clear up that gap... However, I also read about an install where a guy took a socket that cleared the head bolt and hit the socket a few times to move the washer a little down the threads to create enough gap for the Sliders. I have not installed mine yet, so, I cannot give you any first hand experience.