1rider
Well-Known Member
- Thread starter
- #1
I live in Ma. and in a town that uses straight salt without any sand when treating the roads, so when I purchased my truck, I had planned on doing an undercoating. I used Blaster Surface Shield, and it took three cans to do all the undersides of the truck. After spraying it on, I did wipe down all the surfaces to remove the excess and ensure that all areas were covered.
What I liked:
Aerosol cans make the application easy to reach tight spots
The product stuck/bonded well to the frame and seems like it will hold up for a while
It did make the frame shiny or like a gloss finish, which I liked, though not everyone will
Cheap-I think I paid ~$50 for a case of six cans
What I didn't like:
Aerosol spray going in my face due to a slight breeze
Aerosol cans don't spray well if not upright-Not a Surface Shield thing but worth noting
It ruined the clothes I did the work in
I had to take two showers to feel like my surface wasn't shielded-Tyvek suit next time
What I liked:
Aerosol cans make the application easy to reach tight spots
The product stuck/bonded well to the frame and seems like it will hold up for a while
It did make the frame shiny or like a gloss finish, which I liked, though not everyone will
Cheap-I think I paid ~$50 for a case of six cans
What I didn't like:
Aerosol spray going in my face due to a slight breeze
Aerosol cans don't spray well if not upright-Not a Surface Shield thing but worth noting
It ruined the clothes I did the work in
I had to take two showers to feel like my surface wasn't shielded-Tyvek suit next time
Sponsored