Wiring a 8 Gang Switch Panel -

[krabito12]

Purchased a Lasfit 8 gang switch panel for my 2021 Gladiator. The Lasfit looks exactly the same as the Auxbeam switch. Trying to figure out where the "ACC" red wire plugs into the fuse box. Can a labeled "spare" location (from the Manual) be used? Lasfit was not much help. Couple youtube video's suggest the heated seat port (if not in use), the wireless speaker port (again if not in use). Any suggestions? Thanks

Sponsored

 

[PuddleJumper]

personally I wired mine to with a small inline fuse to the power cable of the box. I wanted to be able to turn all my stuff off and on without the truck being on. But yeah you can just do the wireless speaker or just fuse tap any of the smaller fuses in the engine bay box. Just look at a fuse diagram and do whatever is comfortable for you.

 

[steven1955]

I use a fusetap plugged in to the fuse 52 position for my Wolfbox mirror camera. I may be adding a second fusetap to that fusetap if I tie my Voswitch JL300 switch box. These are both low current loads and should not overload the original fuse 52 circuit.

 

[cranbiz]

VOSwitch says fuse 52 and that's what I used for mine. The VOSwitch has the option of ignition switched or always on. I wouldn't be surprised if the Auxbeam ot Lasfit switch does too.

 

[krabito12]

Thanks, all. Think I'm going with the power option so can use when the Jeep is off.

Sponsored