Help me identify this clip

[Zlewis]

Does anyone know what the part number is for the clip circled below?

Sponsored

 

[AyeCantSeeYou]

@AllMoparParts.com would be the best person to ask. Benny is very helpful and active here.

 

[SargeDiesel]

I was going to say... AAZIPTIEAB just kidding ?

Buy yeah, Moparparts can help.

 

[Sweetums]

Easy field repair for that if it's broken or missing: Two zip ties loosely around each hose, then join them with another tie. You can space it by adding additional ties to the link as spacers.

 

[Hootbro]

I went through this years ago on a RAM truck. The clip comes with the coolant hose and is not a separate order part. Want a new clip, have to get a new hose.

 

[AllMoparParts.com]

Sorry but this only appears to be serviced with a new Rad hose assembly. Im pretty sure you can find a good generic equivalent on amazon though.

- Benny

 

[Cburd61]

If you have an u-pick junk yard nearby, you may be able to find one on a junker. I’m always snagging oddball clips and fasteners when I go. They usually don’t charge me for them.

 

[The Other Radio Guy]

Does anyone know what the part number is for the clip circled below?

3D printer go brrrr....

 

[Lost1wing]

Use a nylon bushing/spacer and figure 8 it with a large ziptie.

I have no idea where I got this idea (Boeing or Douglas), but I have seen it used in a very professional manner.

 

[PuddleJumper]

Use a nylon bushing/spacer and figure 8 it with a large ziptie.

I have no idea where I got this idea (Boeing or Douglas), but I have seen it used in a very professional manner.

Well there may or may not be quite a few of uncle Sam's toys built that way. ?

 

[Zlewis]

Dang, thank you for all the responses! I kept running into it looking like I had to buy the whole hose assembly so that makes sense. I guess I'll just use zip ties.

 

[Sweetums]

3D printer go brrrr....

I hope you have some high-temp filament for that print, it gets warm in there.

 

[The Other Radio Guy]

I hope you have some high-temp filament for that print, it gets warm in there.

ABS might work.

 

[Lunentucker]

Look at "stud mount tie" and "push mount tie"

Sponsored