Search results

Are those the Mopar ones? I was looking at the Mopar black lug nuts but they are expensive.

Can you charge the ecoflow and run the fridge off of it at the same time? Thinking of running a similar set up.

Do you happen to know how I can check if I have the 4th pin? Mine was built in October 21.

Thanks you!

Are you running the factory upper control arms? Asking because I have the mopar lower control arms and Claytons .5 diesel front springs and like the ride, but might switch to the springs you're running when I add a winch.

Any idea if the halos will work on a sport s?

No, all it is is a seal similar to what comes on the factory intake. I can post a picture later if you want.

I have a hard time understanding how and why that thing cost almost $800. Hopefully it does something!

No, I do have the MBRP sitting in my garage that I haven't gotten around to installing yet. I'm not expecting much from it but at $180 it's not a huge investment.

I have it, and I have no complaints. I did a 0-60 with my tazer before and after and shaved off about half a second. I also modified it and cut out a portion of the bottom of the box so it pulls air directly from the inlet that comes from the front of the grill. Ive also tried it both with the...

I get your concerns. I have those springs on my JTD and while it is unnoticeable by just looking at it, the passenger side does sit about a 1/4 inch lower than the driver side.

What about diesel Rubicon springs for the front? Or these https://www.claytonoffroad.com/product/jeep-wrangler-jk-jl-15-front-coil-springs-jeep-gladiator-jt-05-lift-front-coil-springs

I actually just replaced my front springs with the Clayon diesel springs along with metalcloak coil pads and bump stops and the ride is a lot better.

Ok

I saw that after I had already ordered this mount. I'll probably end up going back and using that mount to make the install cleaner eventually.

Installed the Banks Idash and pedal monster today. Not the cleanest install but it will do for now. Now just to figure out what I want to monitor on here.

Today I installed the Clayton diesel front springs along with the metalcloak coil pads and daystar 3/4 in spacers front and rear. Already had the metalcloak bump stops installed as well. The ride has significantly improved and no longer bottoms out. The Clayton springs are well worth it if you...

Has anyone found an aftermarket skid plate for the fuel filter? After watching a guy destroy his on the rubicon Im thinking its a good idea to have a sturdier skid plate.

Never mind I see you have Bilsteins in the front.

Did you keep the stock shocks or go with aftermarkets or extensions?