Alans17
Well-Known Member
- Thread starter
- #1
I’m not saying I should, but it seems like I could...
Similar to installing 12v in the bed, I’m wondering about drilling out the soft plastic bezel around the fog light and adding a 12 receptacle up front. If I did it (and I’m not saying I would), I’d route it through the aux panel so I could switch it on and off at will.
The only potential issues I see are it getting dirty or damaged. Trying to use it in such a state would be unsafe. Thus the aux panel wire-up. And to avoid anyone tampering with it.
As for benefit... I’ll admit there’s not much if I already have one in the bed. Just thinking it might be fun to do.
Similar to installing 12v in the bed, I’m wondering about drilling out the soft plastic bezel around the fog light and adding a 12 receptacle up front. If I did it (and I’m not saying I would), I’d route it through the aux panel so I could switch it on and off at will.
The only potential issues I see are it getting dirty or damaged. Trying to use it in such a state would be unsafe. Thus the aux panel wire-up. And to avoid anyone tampering with it.
As for benefit... I’ll admit there’s not much if I already have one in the bed. Just thinking it might be fun to do.
Sponsored
