Blindjustice1787
Well-Known Member
- Thread starter
- #1
I have a request for anyone who owns one of these bad boys!
can you measure the width of the x4s from center of t-slot to center of t-slot? (To be clear, I mean left to right/right to left not front to back)
2. can you measure from the center of the t-slot to the edge of the cover on the same side? Trying to see how much clearance is needed.
3. With the cover rolled, can you take the same measurement as 2, but from the top of the roll to the t-slot? (Put a square, level, plumb Bob, etc in the center of the t-slot and measure to the top of the roll? Just verifying there is not lateral movement when It is rolled)
4. The height of the rolled top? (I need to calculate if a slanted vertical member will allow the roll to clear so I need this measurement to check.
can you measure the width of the x4s from center of t-slot to center of t-slot? (To be clear, I mean left to right/right to left not front to back)
2. can you measure from the center of the t-slot to the edge of the cover on the same side? Trying to see how much clearance is needed.
3. With the cover rolled, can you take the same measurement as 2, but from the top of the roll to the t-slot? (Put a square, level, plumb Bob, etc in the center of the t-slot and measure to the top of the roll? Just verifying there is not lateral movement when It is rolled)
4. The height of the rolled top? (I need to calculate if a slanted vertical member will allow the roll to clear so I need this measurement to check.
Sponsored