Clayton Off-road part

[MSFTMatt]

Hey @Claytonoffroad, or anyone who might know. I am prepping to install my 2.5” Overland and checking to ensure everything is good to go. Unboxing the front lower control arms this piece was just floating in the box. All the rest are secured to where they belong. Any issue here or just install with it sitting in its place but not secured like the others?

Sponsored

 

[SD Rider]

Go the the source.
@Clayton Off Road

I see that you tagged, but I don't think you tagged correctly.

 

[MSFTMatt]

Go the the source.
@Clayton Off Road

I see that you tagged, but I don't think you tagged correctly.

Thank you very much!

 

[Clayton Off Road]

Hey @Claytonoffroad, or anyone who might know. I am prepping to install my 2.5” Overland and checking to ensure everything is good to go. Unboxing the front lower control arms this piece was just floating in the box. All the rest are secured to where they belong. Any issue here or just install with it sitting in its place but not secured like the others?

Hey there! These are just knurled washers we use on some of the control arms to provide some additional clamping force, they can just be installed at the time you are putting the through-bolts in and they will get the job done!

Sponsored