GlacierGladiator
Well-Known Member
Unscrew antenna, remove plastic trim over antenna housing (or break off plastic). Unscrew the 3 bolts holding on the bracket, disconnect antenna wire & push back into fender, clean area real good with rubbing alcohol & apply trail rated badge.Is the badge the same as the driver’s side? What was the process to make it happen?
The indent in the passenger side fender is the exact size as the driver's side so the badge is the same as the driver's. You don't have to worry about patching over the holes where the bolts were or antenna comes out cause it's a wet fender system and if water some how makes it past the adhesive back of the badge it will drain out somewhere underneath the vehicle and not make it inside.
Hope my explanation made sense.
Sponsored