Halogen to LED Upgrade - Wiring question (I think?)

[wader303]

Hello Everyone,

My '22 JTR came with factory halogens which I upgraded to the DV8 LEDs a few months ago. I taped into the green wire on the factor harness (did't need to make any changes with a Tazer) and the turn signals have worked perfectly since then. Last night I installed a set of Mopar LED turn signals (replacing the original factory lighting harness) and when I tested everything the turn signals worked fine. Tonight I drove my rig for the first time and am now getting warning lights that the turn signals are not working. Any help is greatly appreciated. Thank you.

Sponsored

 

[ecidiego]

https://www.jeepgladiatorforum.com/...ng-as-it-has-rubicon-flares-mojave-etc.66275/

You need to turn on a few things as well as turn off a few things since you have halogen wiring. All covered in my post.

 

[wader303]

Copy that, thank you sir. Can I leave the wiring as-is and turn everything off with Tazer mini?

 

[ecidiego]

Copy that, thank you sir. Can I leave the wiring as-is and turn everything off with Tazer mini?

If you leave the wire you may have codes when scanned. Nothing lights up in the dash tho. Check all of the settings I mentioned, and turn Diagnostics off in all 3 places.

This should work:

LED Dedicated DRL Present: Yes
LED Front Park/Marker Lamps Present: Yes
LED Front Turn Lamps Present: Yes

Left Front Lamp Diagnostics Present - Pin F25: No
Right Front Lamp Diagnostics Present - Pin F28: No
Front Turn Lamps Diagnostics: No

 

[wader303]

Ok so I did what I could with the tazer and everything is working with no error codes. But now the halos on the DV8 headlights aren’t blinking when the turn signals are engaged ?

Sponsored