JT with Dynatrac 60 and ABS Errors

[ThreeSpore]

While I await a response from Dynatrac, I am also checking whether anyone else has encountered this issue and has a solution.

I just installed my new Dynatrac Pro Rock 44/60 setup, and my Jeep Gladiator is throwing rear ABS errors that are effectively shutting down my rig.

I replaced the rear ABS sensors on both sides, but the errors persist. I do have a noticeable difference in the tone rings between my original and the Dynatrac one. I took some pics, as the teeth for the 60 are considerably larger than the OEM.

OEM

Dynatrac

Not sure if that’s an issue?? I have both a J-Scan and a Tazer as needed for programming. Right now, I have the tazer, unmarried, and using the JScan. I have confirmed my axle and tire settings are correct and have initialized the ABS after the updates. Also, here is a picture of the ABS sensor gap if that's also something to look at.

Any ideas/help/experience? Thanks to anyone who pitches in!

Sponsored

 

[ThreeSpore]

Some news: the sensor-to-tone ring gap is too large. Needs to be 0.030". It's 3/16" so that's going to be an issue, I feel. Awaiting further guidance from Dynatrac, as I see no way to modify that easily just by looking at it. Any ideas?

 

[nbennettksu]

Inclined to think tone ring issue; hopefully they get back to you with an adjustment method

Sponsored