KBD Fender Flares

[Ragnarock_jeep]

Just installed them. Ran into an issue with the lights just flashing. Anytime truck is on, they just flash. installed a resistor (recommended one from KBD) on driver side. No change.

anyone have this issue?

Sponsored

 

[Thisxguy]

I have the same similar issue as well. I drove the car today and it's like the hazards are on. I didn't notice it yesterday but I didn't look. I just noticed it when I got home and was sitting on the driveway. I didn't install a resistor since I had LEDs and my Tazer is all set to LED. Anyone have any recommendations?

 

[Reo Cook]

Same for me. Tried the tazer, load equalizers and still getting either hyper flash or intermittent turn signal blinking on driver side for no reason. Ordered a set of DV8s and will be pulling them off. Too frustrating to continue to fight them

 

[Thisxguy]

Strangely I went to try them out just now and they're working fine. I'll keep an eye on it. I saw that the Tazer instructios say if you have factory LED lights to turn the LED function off and on to try and clear the hyperflashing. I didn't have to do it since it works fine. But I'll try it again if it does it

 

[Thisxguy]

Update: On my JL Tazer, per the instructions, I turned the LED lights setting off then on, and then I reset the system twice. This has completely fixed my hyperflashing issue

I now need probably cap off the extra wires for the load equalizers since they started blinking when I washed my fenders with the car on. Other than that there are no issues even when ESS is enabled.

 

[Camaroboi13]

Still waiting to see what a painted version looks like. Not a fan of the black but this is one of the few fenders that has an LED light on it that’s not just an afterthought.

 

[Viking1276]

I have the same similar issue as well. I drove the car today and it's like the hazards are on. I didn't notice it yesterday but I didn't look. I just noticed it when I got home and was sitting on the driveway. I didn't install a resistor since I had LEDs and my Tazer is all set to LED. Anyone have any recommendations?

Did you ever get a fix for this? Mine do the same. No indicators on the dash but the turn signals flash as if I have the hazards on. I have the taser and set it to LED and it didn't work. Got the turn signal out warning. I put the resistors in and don't get the warning anymore but they flash like I have the hazards on.

Sponsored