Pliny
Active Member
- Thread starter
- #1
I installed the winch mount plate yesterday. I was surprised that the OE steel bumper isn't flat where the fairlead mounts:
Is this normal? The supplied bolts were much too short so haven't mounted the fairlead yet. I wouldn't expect that torquing the fairlead bolts to cause that section of bumper to get pushed in. Is that actually what is going to happen? Or should I get washers to fill that gap?
Thanks,
Philip
Is this normal? The supplied bolts were much too short so haven't mounted the fairlead yet. I wouldn't expect that torquing the fairlead bolts to cause that section of bumper to get pushed in. Is that actually what is going to happen? Or should I get washers to fill that gap?
Thanks,
Philip
Sponsored