garzilla
Well-Known Member
- First Name
- Fred
- Joined
- Apr 2, 2021
- Threads
- 16
- Messages
- 313
- Reaction score
- 437
- Location
- Helotes, TX
- Vehicle(s)
- 2021 Jeep Gladiator
- Occupation
- Software Engineer
- Thread starter
- #1
Welll... I've grown tired of the factory alpine system. It's ALMOST enough but even after replacing the speakers it needs just a little more oomph. Doesn't help that i just helped my son install a 1200w amp w/dual 10s in a ported box with infinity kappa components pushed by a sundown amp. Yeah... I got the itch lol.
So, I'm starting plans for a sub box that goes under the passenger side rear seat. I still want some storage under there and the driver side should do fine.
There is a box from brp that I am going to emulate because it also keeps storage. I want to use a single 10 kicker l7t or JL 10tw3 BUT I want to port the box with an external port extending along the front edge of the box.
The only problem is the volume - the box says it's .7 cu ft but the numbers don't add up. Using various calculators the most i can get on the passenger side without raising the seat is .7 cu ft but that includes going wider than the pictured box and building back where the jack would go.
This is the one I am copying - this shows .7 cu ft on their site
I would incorporate the below design from ground shaker to maximize airspace
But on their site this only shows .55 cu ft which seems low when full boxes are at 1.3-1.4 cu ft and this is like 60%. I also don't want the extension on the right if I don't really need it.
Two 8" l7 shallow in a sealed box is my second choice if I can't get the 10" ported to work out.
Things I've ruled out -
all in one options. I use the locked storage beyond the rear driver seat a lot and I want more thump than that.
Fiberglass - did that before and I made a huge mess. I know myself

Behind the seat - looks like way too much work.
I listen to everything from thrash to rap to country. So I want tight bass but a little dig from time to time.
I'm starting the build i about 2-3 weeks.
So, I'm starting plans for a sub box that goes under the passenger side rear seat. I still want some storage under there and the driver side should do fine.
There is a box from brp that I am going to emulate because it also keeps storage. I want to use a single 10 kicker l7t or JL 10tw3 BUT I want to port the box with an external port extending along the front edge of the box.
The only problem is the volume - the box says it's .7 cu ft but the numbers don't add up. Using various calculators the most i can get on the passenger side without raising the seat is .7 cu ft but that includes going wider than the pictured box and building back where the jack would go.
This is the one I am copying - this shows .7 cu ft on their site
I would incorporate the below design from ground shaker to maximize airspace
But on their site this only shows .55 cu ft which seems low when full boxes are at 1.3-1.4 cu ft and this is like 60%. I also don't want the extension on the right if I don't really need it.
Two 8" l7 shallow in a sealed box is my second choice if I can't get the 10" ported to work out.
Things I've ruled out -
all in one options. I use the locked storage beyond the rear driver seat a lot and I want more thump than that.
Fiberglass - did that before and I made a huge mess. I know myself
Behind the seat - looks like way too much work.
I listen to everything from thrash to rap to country. So I want tight bass but a little dig from time to time.
I'm starting the build i about 2-3 weeks.
Sponsored