Reset error code for rear sensors

[RJK]

I just changed rear bumper on my 2020 Gladiator Rubicon. After transferring the rear sensors to the new bumper I get a message that the rear sensors are not recognized. Anyone know what I can do to reactivate the rear sensors?

Sponsored

 

[PuddleJumper]

I just changed rear bumper on my 2020 Gladiator Rubicon. After transferring the rear sensors to the new bumper I get a message that the rear sensors are not recognized. Anyone know what I can do to reactivate the rear sensors?

assuming you put em back in the right order. maybe just clear the code? or you could cycle to sensor option off and then back on with a Tzer JL or similar.

 

[RJK]

I just changed rear bumper on my 2020 Gladiator Rubicon. After transferring the rear sensors to the new bumper I get a message that the rear sensors are not recognized. Anyone know what I can do to reactivate the rear sensors?

 

[RJK]

Yes I was very careful to put the sensors in the Same position as they were on the OEM bumper. I had to buy new plastic housings for the center sensors because the new bumper was flat, not curved like the OEM bumper.

 

[OHJeeper]

Maybe obvious, but are you 100% sure all the connectors are seated properly?

Sponsored