Tuffy Front Flip Plate

[chrisblaze]

Is anyone using this front flip plate:

Tuffy Flip-Up License Plate Holder for Winch W/Hawse Fairlead 01-Black https://www.amazon.com/dp/B01N4AKOE...abc_9B0R8JBF7ASTSXPGX373?_encoding=UTF8&psc=1

If so, was there any issues with the install?

Sponsored

 

[Rockabillyroy]

i had one on my wrangler. The only issue I had was that it didn't stick out far enough for the factor55 flatlink that I had.

 

[jtimbrook]

I currently have one on my set up right now, It's good if you're using a traditional hook or the the flatlink from Factor 55, will not work with the Prolink unless you leave it out. Install was super easy as it goes on at the same time as the fairlead, adjust the side nuts for desired tightness.

 

[chrisblaze]

Good to know, I have the regular hook for now and I need to make my Jeep Texas complaint.

 

[jtimbrook]

Good to know, I have the regular hook for now and I need to make my Jeep Texas complaint.

I've had mine tilted with no issues from local police so realistically you could run a Prolink and have it angled without being harassed. Then again I've seen the police here not bat an eye with guys running their license plates on the down angle of skid plates, so there is that...

 

[bgenlvtex]

Yes and as noted will not clear a F55 flatlink.

So I bent up a new license plate holder out of hot roll

that sticks out further.

 

[49Gramps]

While pricey, I went with the "Flipster" (Cascadia 4x4) on my LJ some 8-10 years ago. Very well-made unit!

Sponsored