Bass knob mounting... where did you put yours?!?

[blau iii]

I'm finalizing the designs for a behind the rear seat, two 10" sub box and want to discreately mount a bass knob near the drivers seat to control the amp volume. I saw a you tube video (link below) where the guy 3D prints a replacement for the cigarette lighter that would be perfect but I can barely spell CAD let alone design something... Any other suggestions or ideas on where to mount the knob?

Sponsored

 

[Jud1118chills]

I'm finalizing the designs for a behind the rear seat, two 10" sub box and want to discreately mount a bass knob near the drivers seat to control the amp volume. I saw a you tube video (link below) where the guy 3D prints a replacement for the cigarette lighter that would be perfect but I can barely spell CAD let alone design something... Any other suggestions or ideas on where to mount the knob?

 

[Mr.Spradlin]

Under the park brake. If you remove the rubber insert there is a hole that the rubber insert pops into. The MB Quart bass knob fit perfect. Just had to cut the nipple off and drill a hole where the nipple was in the rubber insert.

 

[blau iii]

Under the park brake. If you remove the rubber insert there is a hole that the rubber insert pops into. The MB Quart bass knob fit perfect. Just had to cut the nipple off and drill a hole where the nipple was in the rubber insert.

thats super clever!!

 

[Mr.Spradlin]

thats super clever!!

Found it by looking to see if there was any screws under the rubber insert. Just got lucky.

 

[blau iii]

Is anyone using the knob from the PAC to control their subs or are you guys using the one that goes with your amp? I can't find any pics online of how the PAC knob is put together or if it breaks down so you can hide it behind something.

 

[XraytecH]

Not as fancy as Car Audio Fabrication's but it's inexpensive and simple. Only had to modify the bezel around the knob to have it sit flat.

https://www.amazon.com/gp/product/B012YH546G/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&psc=1

 

[Kirk_Dirksen]

Not as fancy as Car Audio Fabrication's but it's inexpensive and simple. Only had to modify the bezel around the knob to have it sit flat.

https://www.amazon.com/gp/product/B012YH546G/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&psc=1

That looks super clean. Very nice.

 

[Jeepmonster]

Is anyone using the knob from the PAC to control their subs or are you guys using the one that goes with your amp? I can't find any pics online of how the PAC knob is put together or if it breaks down so you can hide it behind something.

I just saw your post. I installed a PAC APSUB-CH41. The included knob didn't come with a housing, as it was likely intended to be mounted into a panel. I ordered small electronic cases from Amazon and mounted it with double sided tape.
https://smile.amazon.com/gp/product/B07F3Q784X/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Sponsored