Anyone using the Metalcloak 3.5" dual rate lift kit?

[MALLCRAWLER]

looks like a solid kit. I have one on the way with a set of fox 2.0s on the side.

Anyone have experience with it or install tips? Did I done goof?

Sponsored

 

[THE SANDALORIAN]

Can't go wrong with MetalCloak. I had their 3.5" Game Changer lift on my JKU and just installed the kit on a Wrangler LJ and my Wrangler TJ. Very high quality product.

The install instructions are really good and their support is top notch if you need any assistance. I don't really have any tips as the process on all three Jeeps went smoothly.

P.S. I do have a Gladiator lift tip from my Clayton install but will apply to the MetalCloak lift as well. Torque spec of 190lbs on the lower control arms will take some work. Have a good torque wrench with some decent length to it. And don't torque down when off the ground, wait till you have it back down on the ground on it's own weight. Or have the axles supported on by jack stands.