Codes after lift

[Ssober]

2020 rubicon, metalcloak 3.5 gamchanger 3.5, adams front driveshaft, apex 2.5t steering, aal front bumper with winch

While doing installation instructions damaged the truck side of the front abs sensor wire, I replaced the connector and cleared codes but I am still lit up like a Christmas tree. If I clear I can drive a mile or so and it kicks a light. No cruise, no sway bar, ect.
Need suggestions. I stumped
Not sure if the abs wire is backward and causing all of this or parts took a crap while on the lift.

Sponsored

 

[JeepOfTheseus]

Don't think you can reverse the ABS wire (unless you spliced it by hand).

Since you did the driveshaft and it seems to be complaining about the transfer case...anything go wrong there?

 

[Ssober]

Don't think you can reverse the ABS wire (unless you spliced it by hand).

Since you did the driveshaft and it seems to be complaining about the transfer case...anything go wrong there?

Abs wire was a splice on the vehicle side. Funny thing is I tested it both ways and the way I wired it is how it turned out the light and how it looked like it ripped out.

Driveshaft was straight forward. Unbolt the shaft, knock the nut off, tap the flange, install the yolk, tighten the nut.

 

[MPMB]

'Net sleuthing doesn't give a clear answer.

Start with checking & cleaning all the connections to the transfer case and the DTCM. Double check the wiring harness for any damage.

That's the best case scenario - you find something there. Damaged wires, unplugged connector, dirty connection.

Then you progress to faulty connectors to replace, then up to T-case replacement.

 

[Ssober]

I have tracked it down to a voltage drop. The transfer case sensor just drops voltage every so often. I tried the sensor and it still does it so I take the sensor out off the tree. I toned the power wire and it toned to up by the fuse box. Ground cannot tone. I guess start shaking connectors

 

[Ssober]

I broke down and took to the dealer. Drivetrain control module.

Sponsored