Fox ATS Stabilizer

[rharr]

Yes, but you need the Synergy setup either way to mount on the track bar, right. As the mount on the stabilizer for a JK is a 1 1/2” and the JT track bar is 1 5/8” right? Or am I reading wrong in this thread.

this is what i ordered for the rubicon jt with a 1 5/8 track bar.

https://a.co/d/7Ff4U32 aka SKU: ‎985-02-122

it not the ATS version, but uses all the same stuff except its not adjustable.

I did not use the track bar pin.

this is likely what you are looking for.
https://www.northridge4x4.com/part/stabilizers/983-02-146-fox-2-0-ats-steering-stabilizer SKU 983-02-146

Sponsored

 

[bill61]

Thank you. I didn’t notice the clamp was sized already.

 

[pvn.jt24]

Yes, but you need the Synergy setup either way to mount on the track bar, right. As the mount on the stabilizer for a JK is a 1 1/2” and the JT track bar is 1 5/8” right? Or am I reading wrong in this thread.

No, the JK is also 1-5/8 tie rod.

 

[pvn.jt24]

Damn it, I didn’t realize that I wasn’t getting enough clearance lately and so the remote reservoir has been hitting the top.

How are you guys turning it on a stock Rubicon?

 

[Pliny]

Damn it, I didn’t realize that I wasn’t getting enough clearance lately and so the remote reservoir has been hitting the top.

How are you guys turning it on a stock Rubicon?

The Fox install instructions for the JK version (mounting it on a JK of course) has this:

Don't know if it will work to provide enough clearance on a stock height JTR.

Sponsored