VTBulldog
Member
- Thread starter
- #1
I have been reading a lot on here about exhaust mods and wanting to do a little something with mine. I have a 2020 Overland (gas) and ordered the delete kit from MRT.
https://www.shopmrt.com/19-20-Jeep-Gladiator-MRT-RD-JT-p/92r145.htm
I install was very easy, I read through the instructions and cut away. The instructions list to cut at the weld of the resonator, but according to Dave at MRT, and an engineer, those instructions are off and should be at 1.25" away from the resonator due to the pipe size. I did everything while the exhaust is still on the gladiator and gave me some wiggle room to move the pipe, and then fasten in place. Fit was right on.
I run 33" Goodyear Duratracs so you will be hearing these in the videos too.
All of them are with front windows open and the top in mullet mode.
Wide open throttle from 40 to 55
Full stop to 45 MPH
Cold start video is coming up.
The drone is almost non existent with my tires, and Metallica with drown out the rest. Nice tone now, but will definitely upgrade to full exhaust at some point.
Hope this helps!
https://www.shopmrt.com/19-20-Jeep-Gladiator-MRT-RD-JT-p/92r145.htm
I install was very easy, I read through the instructions and cut away. The instructions list to cut at the weld of the resonator, but according to Dave at MRT, and an engineer, those instructions are off and should be at 1.25" away from the resonator due to the pipe size. I did everything while the exhaust is still on the gladiator and gave me some wiggle room to move the pipe, and then fasten in place. Fit was right on.
I run 33" Goodyear Duratracs so you will be hearing these in the videos too.
All of them are with front windows open and the top in mullet mode.
Wide open throttle from 40 to 55
Full stop to 45 MPH
Cold start video is coming up.
The drone is almost non existent with my tires, and Metallica with drown out the rest. Nice tone now, but will definitely upgrade to full exhaust at some point.
Hope this helps!
Sponsored