Rubi_Rhod
Well-Known Member
- First Name
- Aaron
- Joined
- Sep 2, 2020
- Threads
- 1
- Messages
- 376
- Reaction score
- 749
- Location
- Washington
- Vehicle(s)
- '20 JTR 6MT, '55 Manx Clone Bug
- Build Thread
- Link
Just arrived. This is the kit less the subwoofers. Today was about 5hrs of getting the dash speakers in and the wiring in.
Tomorrow need to drill out for the sound bar speakers, test, tune and button it up.
First impressions are fair. The instructions are mostly there, but you have to go through a couple manuals, and I didn’t like the power wire running through the floor grommet so i ran it over the windscreen. Will check tho as I don’t want to cause a leak there either. Also the plate for the amp is not properly sized for the amps. Its a mm to small. And its nice and nutserted, but off so I could only do 2-3 on each.
Otherwise the speakers and wires and grills are all nice. The harness doesn’t plug back into the factory speaker plugs, you route new lines with factory plugs and its all fabric loomed like factory as well. It really didn’t add too much time to do that bit. Everything has to be ripped out anyway.
Everything looks decent and while I didn’t get the subwoofer, the kit has it all wired up for the third amp. So its a plug and play affair should I want to.
Will check back once all done.
Tomorrow need to drill out for the sound bar speakers, test, tune and button it up.
First impressions are fair. The instructions are mostly there, but you have to go through a couple manuals, and I didn’t like the power wire running through the floor grommet so i ran it over the windscreen. Will check tho as I don’t want to cause a leak there either. Also the plate for the amp is not properly sized for the amps. Its a mm to small. And its nice and nutserted, but off so I could only do 2-3 on each.
Otherwise the speakers and wires and grills are all nice. The harness doesn’t plug back into the factory speaker plugs, you route new lines with factory plugs and its all fabric loomed like factory as well. It really didn’t add too much time to do that bit. Everything has to be ripped out anyway.
Everything looks decent and while I didn’t get the subwoofer, the kit has it all wired up for the third amp. So its a plug and play affair should I want to.
Will check back once all done.
Sponsored
Last edited: