Proximity door locks retrofit on Wrangler/Gladiator, someone figured it out (DIY writeup)

[Gregj]

@Nascarcamper the information you seek is in the attached wire diagram
BSM wire diagram

Gregj

Sponsored

 

[AllMoparParts.com]

Agree on buying from Benny, but that was before I landed on this forum. Now I’m stuck with what I have, which came from a 2023 JT Mojave from what I can figure, I would have thought it had everything also but I definitely know how the auto industry works. I do need to do better inspection of pins, will do that today. But same pin bent in both doors is a far stretch. Just thought somebody knew what pin I should start my inspection with, like I said prior, I also have the BSM only harnesses, will compare today.

What part # harness did you use?

- Benny

 

[Nascarcamper]

SUCCESS!
When I bought my package, off eBay, it came with harnesses for proximity but not for BSM, harness part numbers used were 68325454AH and 68325461AH. So I compared my original harnesses, part numbers 68325453AF and 68325460AF to the harnesses that came with my kit, low and behold there was only 1 wire missing, solid green on driver side and green/white on passenger side. Removed the wires carefully and intergraded them where they were needed, which was main door connector pin hole 21 and mirror harness connector pin hole 4 on both sides and what do ya know, all systems were a go, all works!
Moral of the story, I saved a few bucks but should have just purchased from Benny and been done with it.

Sponsored