Rubicon backspace= 6.0"/+44 offset?

[RS3]

I am looking at a set of wheels for my JTRD with a 17x9 4.75bs. Wanting to confirm the factory bs/offset to see how much more they will stick out or in.

Sponsored

 

[RS3]

My JT hasn't come in yet so I wasn't sure.

 

[JTDay]

www.willtheyfit.com

 

[Mac]

I am looking at a set of wheels for my JTRD with a 17x9 4.75bs. Wanting to confirm the factory bs/offset to see how much more they will stick out or in.

Depending on the tires you will probably have around 2” outside the fender.

 

[RS3]

Depending on the tires you will probably have around 2” outside the fender.

Thank you! That's about what I was thinking it might be. I was thinking I would run the stock tires on them until I am ready for 37's.

 

[RS3]

I had been looking at the Q-tec Rubicon Extreme wheels. Just something simple. I like the classic five spoke design but am thinking the only offset they offer isn't going to work. I don't mind a little poke but not looking for 2+".

 

[Sallaman]

It partly depends on how wide the tires are,
I currently have the 285 tires and 0 offset wheels and they stick out about 1.5” in the front and a little over 1/2” in the back. If i were to put the 315s i want on these wheels they would stick out an additional 1/2”. For me i dont want too much poke so something in the +22 range would be perfect. I picked up some mojave wheels and tires to replace what i currently have because i would rather have not enough than too much poke.. but thats just my opinion.

 

[Mac]

Quadratec sells their own brand alloy wheels which are 17x8.5 with a +10 offset, they will probably have a little past the fender, AEV also makes a few different wheels in the same size with a +25 offset which will be close to flush, actual amount past the fenders will depend on tire size and brand.

 

[unsocbl]

I have the Quadratec Baja Xtreme (4.75) and 315-70/17 tires...they stick out way too much (about 2")

. Just added a set of Roblokz and will see if that helps the messs they make:

 

[willhonkforparts]

In my opinion, 17x9 4.75bs stick out too far with the wide track axles. I'll be looking for something with a positive offset.

Sponsored