What do u have coming in the mail?

[WILDHOBO]

I have a really expensive fuel spout for my Rotopax fuel containers coming my way. The California legal spouts that come with the Rotopax containers should win the Rube Goldberg award for most over complicated fuel spout. Too bad you can't get any fuel to actually pour through those over complicated fuel spouts.

All Metal PAX Nozzle – Ai13 Billet Products

Thank you very much. I yelled out the window at someone with one on his Toyota last week to ask him where he got it. It was a gift and he didn’t know. I’ll happily pay this much to no longer leak fuel and need to give away gas because it’s leaking. I cannot wait.

Sponsored

 

[Sw00per]

A Warn Zeon XD 10S should be arriving tomorrow.

 

[Camaroboi13]

A ball joint press

 

[XraytecH]

K&N Hot Air Intake to replace the same K&N Hot Air Intake that developed a crack in the air box.

 

[XraytecH]

Reached 50K miles and time to change out that "lifetime fill" ATF so decided to upgrade to a better looking trans pan as well. Cant hurt in the AZ furnace

There are two versions of that pan. Hope you ordered the correct one.

 

[WILDHOBO]

SDI elinks and a new Adams 2 piece rear drive shaft. Both should have arrived last week, but ups and FedEx lost both shipments. Adams is remaking the shaft. I’m hoping the SDI shipment arrives today. It’s been in Denver for days.

 

[MaximusTX]

The wolfbox G900pro and a couple custom plates so I can easily lift my spare tire with the tire carrier.

 

[WILDHOBO]

The wolfbox G900pro and a couple custom plates so I can easily lift my spare tire with the tire carrier.

There are two versions of that pan. Hope you ordered the correct one.

Which one is the correct one?

 

[XraytecH]

Which one is the correct one?

The one for 3.6 engine has a cut out to allow for clearance of the exhaust pipe.

 

[MrBones]

Speedflate Air Down/Air Up hose set.

 

[KevinM60]

If I would have seen this last week it would have been a Bluetti AC180 and an Alpicool T50.
They both came this past weekend and are being tested at home. So far so good.

 

[WILDHOBO]

The one for 3.6 engine has a cut out to allow for clearance of the exhaust pipe.

Thanks. Only a matter of time before I pull the tranny.

 

[WILDHOBO]

SDI elinks and a new Adams 2 piece rear drive shaft. Both should have arrived last week, but ups and FedEx lost both shipments. Adams is remaking the shaft. I’m hoping the SDI shipment arrives today. It’s been in Denver for days.

And they’ve arrived. Damn these are going to be sweet. If you don’t have reservoirs on your swaybar links, you’re just not even trying.

 

[van_tri]

Cheapo $60 Bed Mat to protect my gear from getting "sanded" by my bed liner.
6mm Foam piping to stuff into the crevasse of the fender flares.

 

[JAVIERGONZO]

Hopefully my RTX 5080...

Sponsored