mjoneil
Well-Known Member
- Thread starter
- #1
Decided to switch up the placement of the remote chuck for my on board air! Currently my ARB compressor is located in the drivers wheel well.
Parts:
6SS58TZZAC - OEM 4xE cowl
68467793AD - OEM 4xE charging door
ARB 171314 Remote hose kit
ARB 0740203 Stainless Steel hose
Placement of compressor:
ARB stainless steel hose routed up to cowl:
ARB remote chuck mounting bracket:
It's not perfectly centered but there is no issues accessing the chuck or removing the hose when needed. I'm not some master fabricator but if you are, you could design a bracket that would raise it a little bit:
Still needs some paint, then it will be complete!
Parts:
6SS58TZZAC - OEM 4xE cowl
68467793AD - OEM 4xE charging door
ARB 171314 Remote hose kit
ARB 0740203 Stainless Steel hose
Placement of compressor:
ARB stainless steel hose routed up to cowl:
ARB remote chuck mounting bracket:
It's not perfectly centered but there is no issues accessing the chuck or removing the hose when needed. I'm not some master fabricator but if you are, you could design a bracket that would raise it a little bit:
Still needs some paint, then it will be complete!
Sponsored