What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[troymi]

Here’s quick pics. Got installed today. Went at 35 psi and might play with that a little. Ride is better than OE Falkens as expected. Wheels sit about perfect as expected also. Will get to try snow and ice over next couple days. Then melting and I’ll aim for the water!

Sponsored

 

[Gren71]

Reset my clayton off road rear LCAs...they were way too long for a 2in lift.

took off my terraflex rear track bar bracket. It took the track bar from being lower on the drivers side, to higher on the drivers side. In my mind that would make it way out of spec (relatively flat) once I put the TT on the rear. So I pulled it and installed my core 4x4 adjustable rear track bar. I set that to the same as OEM...since the rear is centered. its just stronger than stock and Ive had it sitting for over a year. it needed attention.

hit all the grease points on the front and rear track bars

rust remediation. Found some rust on the frame welds and a few other small places. Now they are all black and nice looking again.

 

[KX L]

Here’s quick pics. Got installed today. Went at 35 psi and might play with that a little. Ride is better than OE Falkens as expected. Wheels sit about perfect as expected also. Will get to try snow and ice over next couple days. Then melting and I’ll aim for the water!

Those are the black pintler wheels not the onyx color---is that correct?

 

[troymi]

Actually they are Savegre 2. Matte black.

 

[chrismeece74]

Got Mopar 2" lift installed along with Black Rhino Warlord wheels 17x9 in Gunmetal and Falken Wildpeak AT3W's in 315/70R17

 

[AnthonyC]

Finally had the 5th mojave wheel mounted with a wildpeak for the spare. Now I can add it into the rotation.

 

[vmiaptetr]

Installed the Mopar 2” lift on my front end. Cold front came in, so I’ll do the rear when the sun comes back out tomorrow.

 

[RecteAgnesConfido]

Installed 50 gallon diesel auxiliary tank...should make those long trips a lot easier.

 

[The White Rabbit]

Got Mopar 2" lift installed along with Black Rhino Warlord wheels 17x9 in Gunmetal and Falken Wildpeak AT3W's in 315/70R17

Just curious how your rig ended up “Master Chief”?

 

[chrismeece74]

Just curious how your rig ended up “Master Chief”?

I retired from the Navy at 25 yrs as a Master Chief

 

[The White Rabbit]

I retired from the Navy at 25 yrs as a Master Chief

My son is on Coronado island right now waiting to drop back in after being recycled.

 

[The White Rabbit]

I retired from the Navy at 25 yrs as a Master Chief

Thank you for your dedication to our country.

 

[doc-ketamine]

With these decals ... do you apply wax over them? Wash the vehicle as normal? Is it safe to go through a car wash or would there be a risk of damaging the decal?

Thanks. I have one of these decals but have been hesitant to put it on (on the hood).

 

[pixeldecals]

With these decals ... do you apply wax over them? Wash the vehicle as normal? Is it safe to go through a car wash or would there be a risk of damaging the decal?

Thanks. I have one of these decals but have been hesitant to put it on (on the hood).

Yes to all your questions. This material is meant for automotive use abs is safe in all those situations.

 

[ArmyMP]

Got Betsy measured for her new vinyl.

Sponsored