813 Fabrication & Design - Under Rear Seat MOLLE Storage Solution

[813 Fabrication & Design]

NEW PRODUCT! One thing Jeep did not do is give us a way to lock the lower seats. What if you could mount your guns, ARB compressor, recovery gear, etc. under the rear seats and lock the seats? Here is the latest item I have been working on. Thought I would show the prototype to see what everyone thinks. Final product will be 1/8" aluminum, texture black powder coat. The setup will be sold as two pieces. A stand-alone MOLLE panel that mounts to the floor and the add-on full surround front that will include the seat brackets, locks, mounting hardware, etc. It’s pretty solid. We will be marketing it as “theft-deterrent”. It won’t be a full-on safe box, but it will for sure make it very hard for anyone to get your stuff! Let's hear some feedback!

www.813fabrication.com

- Video link giving a little more overview

Sponsored

 

[Silverslayer]

I like it. Might like having a rubberized coating or mat to prevent rattles from anything not tied down with molles.

 

[Jeeping Schnauzers]

Count me as a Buyer - Be Great for me

 

[813 Fabrication & Design]

I like it. Might like having a rubberized coating or mat to prevent rattles from anything not tied down with molles.

Sounds like a good idea. But it may need to be something custom cut that the customer adds as it would be hard to give a mat that would work while also letting the MOLLE be used.

 

[813 Fabrication & Design]

Count me as a Buyer - Be Great for me

Great! Shoot me an email, I am putting together a list of those interested so I can keep you updated on production. [email protected]

 

[Jeeping Schnauzers]

Great! Shoot me an email, I am putting together a list of those interested so I can keep you updated on production. [email protected]

[email protected]

 

[Ravenron]

I like it. Might like having a rubberized coating or mat to prevent rattles from anything not tied down with molles.

What about getting it bare and having a Linex or Rhinoliner application? Would keep Molle functional...

 

[Dewyaw]

Watching this. Really like the compressor hookups...I like functionality.

 

[813 Fabrication & Design]

What about getting it bare and having a Linex or Rhinoliner application? Would keep Molle functional...

I would have to have two separate production runs in order to do that. I think the best way would be let the customer, or I can before sending, spray the bottom panel with an undercoating spray. I think that would be more sticky than a bed liner, well, except maybe Rhino Liner.

 

[Nuttall]

I will be interested as well! Looks good!

 

[813 Fabrication & Design]

I will be interested as well! Looks good!

Thanks! I should have some photos of the finished powder coated prototype this week!

 

[Jaxmax]

I am interested also, looks like a lot more storage area then the plastic factory wall thing, not sure I would want the Molle slots, but could put a thin starboard panel on inside to cover holes other then by air compressor for cooling , could put black screens over that area. Be nice to have two air chucks, one on each side. I’ll be following this......Jack

 

[Zacfrac]

Emailed, this looks a lot more functional than the factory locking box.

 

[4xjeepr]

I am definitely interested in this, more so than the plastic lock box some come with. Personally, I only have the non locking box. Let me know when these are available!

 

[Benbean66]

Interested. Good looking design.

Sponsored