RaiderGladiator
Well-Known Member
- Thread starter
- #1
Hello!
First post here! Been reading through these forums for awhile and finally posting. New to this Jeep world, loving every minute of it! There is so much- everywhere! I need a little recommendation with a few parts in regards to gears. I live in Iowa, moderate hills here and not a whole lot of serious crawling or off roading happening.
Current setup
JT overland 3.73 gears:
40k miles, 33” open country r/t’s 33x12.5x18
Fox 2.0 steering
no lift
Upgrading to:
4.88 gears (need brand recommendations w/links?) my shop asked if I could find a loaded front and rear carrier?
New ball joints? (Recommendations)
3.5” Clayton ride right
Fox 2.0 shocks
37” nitto grapplers
(Undecided wheel size)
Adam’s drive shaft after lift.
Can I get some recommendations for front and rear loaded carriers? And/or some recommendations on 4.88 gears to go with? There is so much out there, I would like to make sure I provide my shop with everything they need to get the job done.
Also, I would like to replace the ball joints during this whole process, are there brand recommendations one could provide as well?
Anything else you guys would suggest would be great. Thanks fam!
First post here! Been reading through these forums for awhile and finally posting. New to this Jeep world, loving every minute of it! There is so much- everywhere! I need a little recommendation with a few parts in regards to gears. I live in Iowa, moderate hills here and not a whole lot of serious crawling or off roading happening.
Current setup
JT overland 3.73 gears:
40k miles, 33” open country r/t’s 33x12.5x18
Fox 2.0 steering
no lift
Upgrading to:
4.88 gears (need brand recommendations w/links?) my shop asked if I could find a loaded front and rear carrier?
New ball joints? (Recommendations)
3.5” Clayton ride right
Fox 2.0 shocks
37” nitto grapplers
(Undecided wheel size)
Adam’s drive shaft after lift.
Can I get some recommendations for front and rear loaded carriers? And/or some recommendations on 4.88 gears to go with? There is so much out there, I would like to make sure I provide my shop with everything they need to get the job done.
Also, I would like to replace the ball joints during this whole process, are there brand recommendations one could provide as well?
Anything else you guys would suggest would be great. Thanks fam!
Sponsored