Richord
Member
- Thread starter
- #1
I installed the Mopar Aux switch kit and flashed the computer with the Tazer. The Aux switch shows up in the setting menu but does not work.
I double checked the wiring and started testing to see if I could find any wiring issues. I checked the main 5 amp fuse and it's ok and has 12v to it.
1. I measured the voltage on the red wire on the connector behind the switch. Should there be 12V on the wire? Mine shows 0V
2. The black wire on the back of the switch shows it is ground.
3. Should the orange wire have any voltage on it?
Thanks.
I double checked the wiring and started testing to see if I could find any wiring issues. I checked the main 5 amp fuse and it's ok and has 12v to it.
1. I measured the voltage on the red wire on the connector behind the switch. Should there be 12V on the wire? Mine shows 0V
2. The black wire on the back of the switch shows it is ground.
3. Should the orange wire have any voltage on it?
Thanks.
Sponsored